Naze32 Rev6 è una centralina di controllo per multirotori classe 200-550.
At the heart of the Naze32 is a 32bit ST micro work horse of a processor, with untapped memory and cpu power and a host of equally impressive sensors. The Naze is also matched up with some of the nicest GUI programs and features to get the most out of your configuration.
This "Acro" version is the same as the full Naze32 board except the full version comes with the MS5611 barometer and a magnetometer.
STM32F103CBT6 32-bit ARM Cortex M3 processor (72MHz, 3.3V)
Invensense MPU6500 MEMS accelerometer + gyro
Built-in Micro-USB for programming/firmware update
36x36mm size, ~5 gram weight w/o headers
Made in JAPAN
Shipping with 16V input capable voltage regulators
These come with pin headers (right angle only), NOT soldered to the board.
Here are the changes / improved features compared to previous Naze32 Rev5 Acro
USB Port on the right side
PPM/PWM input as through-hole (it used to be solder pads, and caused some problems when overheat the pads pulled off)
SBUS Inverter (so people won’t have to do the inverter hack on their x4r with Naze32, but it doesn’t seem to support smart port so might not do telemetry. Will confirm later)
Onboard 2MB flash (useful for blackbox)
Built-in BMP280 barometer (Not sure what you can use it for on a Acro board flying rate mode, but better than none I guess)
Fully pinout compatible with rev5 accessories (OSDoge etc)
Compatible with Spectrum satellite
Sonar pads with resistors added for direct connection to 5V sonar
All extra pads (FT, GP, A5) on top, only sonar on bottom
3.3V, I2C on standard-size headers
In the Full version
Different barometers: the full has the ms5611 as the original naze full
It has 128mbit flash memory = 16MB